I

II

2

Low Voltage Directive

CB Report per IEC 60950-1(2001)
First Edition
All National Deviations

1. Each output can deliver its rated load but total output power must not exceed 115 watts.
2. Semiconductor case temperatures must not exceed 110^o C.
3. Sufficient area must be provided around the convection cooled power supplies to allow natural movement of air to develop.
4. This product is intended for use as professionally installed component within information technology and medical equipment.
5. A minimum load of 20% is required on output one to insure proper regulation of remaining outputs. 
6. Peak to peak output ripple and noise is measured directly at the output terminals of the power supply, without the use of the probe ground lead or retractable tip, 20 MHz bandwidth.
7. This product was type tested and safety certificated using the the dielectric strength test voltages listed in Table 5B
   of UL 60950-1. In consideration of clause 5.2.2, care must be taken to insure the voltage applied to a reinforced insulation
   does not over stress basic insulation. Secondary to ground capacitors may need to be removed prior to performing
   a dielectric strength type test on the end product. It is highly recommended that the DC test voltages listed in DVB.1. Annex DVB are not exceeded during a production-line dielectric strength
   test of the assembled end product. Please consult factory for further information.
8. This power supply has been safety approved and final tested using a DC dielectric strength test. Please consult factory before performing an AC dielectric strength test.
9. Maximum screw penetration into chassis mounting holes is .250 inches.